Laser Sys*Stim 540 with SLD/LED Cluster Applicator

The Mettler Electronics Laser Sys*Stim™ comes with a SLD/LED cluster probe with 950 nm SLDs and 660 nm LEDs. An optional 785nm laser applicator is also available. 

The Laser Sys*Stim allows the clinician to set treatment time, continuous/pulse modulation modes and laser output energy. All treatment parameters are displayed on the LED displays and controlled via the membrane keypad. There are holders integrated into the unit to store applicators when not in use. Laser output can also be adjusted via controls on the both laser and cluster applicators.

Specifications:
Voltage: 110 to 240 Volts AC
Frequency: 50/60 Hz
Power: Less than 150 VA
Battery: Sealed lead acid, 12 Volt, 0.8 AH
Operation time on battery: Greater than 30 minutes
International standards: EN60601-1 1990 EN60601-2-22 1996
Laser output meter: Infrared photo sensor integrated into the top panel.

Cluster Applicator Specifications:
SLD: Twelve 950 nm Super luminescent Diodes
LED: Seven 660 nm Light Emitting Diodes Total Power 500 mW
Treatment area illumination: The 660 nm LED’s are visible and illuminate treatment area
Output activation: Capacitance switch on applicator handle
Treatment area: 3.4 cm²
Eye protection: Uvex glasses with a minimum of 80% attenuation in the wavelength range of 780 nm to 1200 nm. The Uvex glasses supplied with the unit meet these requirements